LPT
12
2.3
Assembly
Before assembly, take a close look at the individual assembly steps shown and carry
out the assembly in the order given.
L
NOTICE
First loosely screw all parts together and check that they fit properly. Tighten the
screws using the tool only when you are instructed to do so.
Step 1:
Assemble base frame
1. Attach four 50x50mm endcaps (19) to both ends of the front stabilizer (2) and the
rear stabilizer (3) as shown.
2. Mount the foot plate (9) to the front stabilizer using the foot plate holder (14) and
a 5/16” X 1/4” inner hex screw (61).
3. Mount the front stabilizer (2) to the base frame (1) using two 3/8” X 2-3/4” hex
bolts (55), four 3/8” washers (63) and two 3/8” nylon nuts (66).
4. Mount the rear stabilizer (3) to the base frame (1) using two 3/8” X
3-1/8” hex bolts (53), four 3/8” washers (63) and two 3/8” nylon
nuts (66).
5. Insert the two guide rod holders (24)
completely into the rear stabilizer (3) as shown.
6. Insert both guide rods (6) into the 420mm spacer (13) and
the guide rod holders (24) and mount them using two 3/8”
X 1” hex threaded bolts (57) and two 3/8” spring
washers (65).
Summary of Contents for BC-LPT
