32
4.3
Mounting the side rails
The comfort/nursing care bed stellar can be equipped
with side rails. The comfort/nursing care bed should be
moved to its uppermost position (1) to enable the instal-
lation of the side rails. This considerably simplifies the as-
sembly.
In order to install the side rails, the side padding must be
removed. This is attached to the lying surface at three
points (2).
Remove the six grub screws (3) that secure the side panel
to the lying surface. This requires a size 4 Allen key. The
screws are located underneath the lying surface.
When all screws have been removed, the side panels (4)
can be removed from the lying surface. To do this, grip
the lower edge of the panel and pull it away from the
comfort/nursing care bed. The panel can then be lifted
upwards from the aluminium longitudinal beam.
Now the telescopic posts can be mounted on the lying
surface. To do this, hang the telescopic post with the
bracket into the aluminium longitudinal beam. This tele-
scopic post must then be pushed towards the end of the
lying surface (5). Make sure that this is not pushed be-
yond the length of the lying surface. The lying surface
must still be visible when viewed from the front.
