35
APPENDIX I
– RECEIPT MODE
The Lemur-C may be configured from the factory for use with receipt roll stock.
Ticket Load Procedure
•
Turn the printer on and wait five seconds. If your printer has an optional LCD then it will display PAPER OUT (the
red CHECK PAPER led will be illuminated).
•
You need to make sure the leading edge (first part that is feed into the printer) has a nice clean edge. Not
crumpled or tape stuck to it.
•
Begin loading the tickets through the entrance slot with a smooth motion until it stops. At this point the printer will
automatically grad and positions the receipt paper.
•
After the ticket is automatically positioned (the READY LED will be illuminated), press the TEST button located on
the control panel to print a test ticket. The printer is configured when it leaves the factory to be particle cut the
receipt. Self-test printout should look similar to the image below.
•
Printer is now ready for operation.
