BobsCNC Evolution 4, Assembly Manual, Page: 9 / 139

8
Assembly Recommendations:
Use a large, flat, clean work surface for assembling your EVOLUTION 4.
All Screws (unless noted) should be installed snug, then rotated 1-2 ½
turns.
Light sanding may be required to remove any marks made by the laser.
Painting, or applying stain with a clear coat will provide extra protection to
the wood components
Try using strips of 1 inch blue painters’ tape behind the T-Slots to help hold
the Nuts in place during assembly.
Lock Nuts are never used to secure components that have T-Slots. They
are only used to mount components where the Nut is not held in a
T-Slot.
CAUTION
This kit contains numerous small
components that pose a choking risk for small
children and pets. Keep kit pieces in a secure
location out of the reach or small children and pets.