Bob’s Space Racers Inc. |
Rescue 1™ Operator’s Manual (V1.SEPT2014)
14
4.
I
NSTALLATION
(C
ONTINUED
):
4.8
Adding water to the game:
1.
Add 10 gallons (40L) of clean tap water to the holding pan located directly in
front of the water guns.
NOTE: Do not add any additives, chemical cleanser,
or deionized distilled water into the holding pan. Clean tap water is best.
2.
Before powering on the game, open the access door to the pump.
3.
Insert the normal screwdriver into the shaft of the pump and turn it with a
screwdriver.
If the shaft turns smoothly, then the pump will operate smoothly. If the shaft does not
turn smoothly, then apply an increasing amount of force to ensure that the shaft will turn
smoothly. This will break away any corrosion that may have built up inside the pump
impeller or housing.
4.
After confirming that the shaft turns smoothly, power can then be applied to
the game.
5.
Run the game and look for proper operation of the pump.
Note:
There is potential for the water to freeze if kept in an area where temperatures
decrease below freezing point.
DO NOT RUN THE GAME IN FREEZING TEMPERATURES!
Running the game in freezing temperatures could cause the water pump to potentially
burn up if the water inside the pump housing is frozen. Remove the water from the game
and water pump before freezing temperatures are reached.
DO NOT
operate the game with no or too little water in the game. This will cause the
water pump to overheat and potentially burn up.
Insert the screwdriver into axostyle of the
pump to move the axostyle with
screwdriver. Make sure the axostyle can
run smoothly before connecting the power.
axostyle of the pump
