71
Operator’s Manual Simple AFG Application
Berkeley Nucleonics Corporation
[email protected] | www.berkeleynucleonics.com
2955 Kerner Blvd, San Rafael, CA 94901 | 800-234-7858
Rev 1.1
•
Now you can send the SCPI commands to the AWG5000 resource using the NI Visa Test Panel.
Channels and Device Setting
Press this button
to open the settings page composed by N +1 number of tabs, N for each
Channel of the instrument and one for the Device. You can swipe left or right to switch among the tabs.
Touching a channel button
or pressing the “CHANNEL SEL.” button on keypad the settings page
will switch between the channel’s tabs.
Channels Settings
Touching the Setting button
or the “SETTINGS” button on keyboard, the setting page opens.
Channel Setting Description
Initial Delay
Set the Initial Delay of the selected channel. The delay range is 0s to 10 s.
Load [Ohm]
The instrument applies the appropriate scaling to the output waveform to get the
right amplitude on the defined Load expressed in Ohm.
The impedance range is 1 Ohm to 1 MOhm.
