68
Operator’s Manual Simple AFG Application
Berkeley Nucleonics Corporation
[email protected] | www.berkeleynucleonics.com
2955 Kerner Blvd, San Rafael, CA 94901 | 800-234-7858
Rev 1.1
Remote Control
The “Remote” button
located in the Command Bar opens the page of the SCPI server. In that
page there is the list of all the commands received by the SCPI server and its replies. If the text of the
command is displayed in
green
it means that the command is correct and it has been accepted by the
server. If the text of the command is displayed in
red
it means that the command is wrong and it hasn’t
been accepted by the server.
At the top of the page the Host Name and the IP Address of the instrument are shown. The slider on the
right side of the page allows to enable or disable the SCPI server. By default, it is enabled.
GPIB and USBTMC
(with GP-IB / USB-TMC option only)
While the VXI-11 server is always available to remotely control all the parameters of the instrument,
with GP-IB / USB-TMC
option the AWG5000 series is provided with a GPIB electronic interface and a
USBTMC port (refer to the Programmer manual for a complete description of all instrument setting
commands and data transfer commands).
