Thank you for purchasing a BN Thermic product. Manufactured to a high standard, this product will, if used according to these instructions and
properly maintained, give you years of trouble free performance.
1 . SA F E T Y I N ST R U C T I O N S
1 . 1 ELECTRICAL SAFETY
❑
WARNING!
It is the responsibility of the owner and the operator to read, understand and comply with the following:
You must check all electrical products, before use, to ensure that they are safe. You must inspect power cables, plugs, socke ts and any
other connectors for wear or damage. You must ensure that the risk of electric shock is minimised by the installation of appropriate
safety devices. A Residual Current Circuit Breaker (RCCB) should be incorporated in the main distribution board. If in any doubt consult a
qualified electrician. You must also read and understand the following instructions concerning electrical safety.
1.1.1 The Health & Safety at Work Act 1974 makes owners of electrical appliances responsible for the safe condition of those appliances and the
safety of the appliance operators. If in any doubt about electrical safety, contact a qualified electrician.
1.1.2 Ensure that the insulation of all the cables on the appliance is safe before connecting it to the power supply.
1.1.3 Ensure that the cables are always protected against short circuit and overload.
1.1.4 Installation should always be carried out by a qualified electrician in accordance with current electrical regulation, protected by a suitably rated
isolator and fuse or mcb.
1.1.5 This Mirror must not be installed in a Zone1 area of any room (see Zone drawing below).
2 . I N ST A L L A T I O N
THESE INSTRUCTIONS SHOULD BE FOLLOWED TOGETHER WITH MIRROR MANUFACTURER’S INSTALLATION INSTRUCTIONS
This demister is designed to be used safely in Zone 2 or 3 of a
wet room (see drawing to the right).
2.1.1
The demister is best connected to a switched lighting
circuit, so that it is activated when the light is turned on.
2.1.2
The demister can also be wired to a separate On / Off
switch but this switch must be suitable for the area in
which it is to be used and placed in a position that it
cannot be touched by a person standing or sitting in
the bath / shower.
2.1.2
Stationary appliances without a means of all pole
disconnection from the supply must have a disconnect
device incorporated into the fixed wiring circuit.
2.1.3
The wiring regulations also require a double pole RCD
to be installed for all fixed current using appliances in
zones 2 & 3 in a bathroom.
2.1.4
The wires in the mains cable are double insulated and
coloured in accordance with the following code:-
BROWN:- LIVE
BLUE:- NEUTRAL
2.1.5
Wiring must be covered and inaccessible in compliance with relevant safety standards.
2.1.6
All metal frames surrounding the mirror
must
be earthed and comply with current wiring regulations.
2.1.7
If the mirror has been supplied with a metal foil anti-shatter film then this film
must
be connected to earth due to a possibility of a small
capacitance effect.
2.1.8
The demister is supplied with 1.0m of double insulated cable and cannot be replaced, when a longer cable is required, a suitable junction box
and the correct cable must be used.
Back View
Self Adhesive Side
To be placed facing wall
To be placed on the back of the mirror
INSTRUCTIONS FOR:-
MIRROR DEMISTERS
MD3/5/7 Series
REGISTER
: PLEASE REGISTER THIS PRODUCT ONLINE TO ACTIVATE YOUR GUARANTEE AT
www.
bnthermic
.co.uk
IMPORTAN
T: PLEASE READ THESE INSTRUCTIONS, NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS, AND CAUTIONS.
USE THIS PRODUCT CORRECTLY, AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY
CAUSE DAMAGE AND/OR PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY.
