Installation, assembly and commissioning
for the first time
Version 1.1
Page 52 of 113
4.4
Installation of the battery storage system
Installation steps
Proceed as follows to install the battery storage system:
Step
Description
1
Unpack the battery storage system carefully and check it for transport damage.
In case of transport damage, contact the forwarding agent or the manufacturer immediately.
Do not use a knife to open the packing.
Never
install and operate a defective energy storage unit
2
Check whether all structural parts and accessories exist.
3
Check whether the battery storage system has been switched off.
Both LEDs must not light up.
Use a voltmeter to measure the DC voltage.
4
Bring the battery storage system on the pallet to the installation place using suitable transport aids.
5
Check whether the current isolator (NH isolator) is pulled.
Figure 4-3: representation of the pulled current isolator
The current isolator must be pulled before installation.
