BMW Z4 Roadster, Owner'S Handbook Manual

Page: 166 / 344

other qualified Service Partner or a specialist
workshop.
Display in the instrument cluster
When drive-ready state is switched on,
the warning lamp in the instrument clus‐
ter briefly illuminates in order to show the
operational readiness of the entire airbag system
and the belt tensioners.
Malfunction
▷ The warning lamp does not illuminate
after drive-ready state is switched on.
▷ The warning lamp is permanently illu‐
minated.
Have the system checked.
Not for Australia/New
Zealand: Key switch for
front passenger airbags
Principle
When a child restraint system is used on the
front passenger seat, the front and side airbags
on the front passenger side can be deactivated
using the key switch for front passenger airbags.
General
The front and side airbags for the front passen‐
ger can be deactivated and reactivated using the
integrated key from the remote control.
Overview
The key switch for front passenger airbags is lo‐
cated on the outside of the dashboard.
Deactivating the front passenger
airbags
1. Insert the key and press inwards where nec‐
essary.
2. While the key is pressed inwards, turn it to
the OFF position as far as it will go. Once the
stop position has been reached, remove the
key.
3. Make sure that the key switch is in the end
position so that the airbags are deactivated.
The front passenger airbags are deactivated.
The driver's airbags remain active.
If a child restraint system is no longer fitted in the
front passenger seat, reactivate the front passen‐
ger airbags so that they are triggered as intended
in the event of an accident.
The airbag status is displayed on the indicator
lamp on the roof lining, see page
167 .
Seite 166
CONTROLS
Safety
166
Online Edition for Part no. xxx - X/18