BMW VVDI2, User Manual, Page: 10 / 50

BMW TOOL User Manual
Ver: 2.0
10
5. EEPROM/KM/Sync Code (OBD)
Main menu interface->>>Key Learn->>>CAS/EWS information
OBD main window
(
PICTURE
5.1)
, support following functions:

Auto Detect : Detect communication protocol automatically, support KWP-E6X
…,
CAN bus 100Kbps, and CAN bus 500Kbps. Other functions need choose manually

OBDII KWP
– E6X, E7X, E9X, E81, E82, E87, E89
: Usually used in old cars with
CAS1, CAS2 and some CAS3

KWP
– CAN bus 100Kbps
: This type will be use when VVDI2 connect to CAS with
CAS PLUG or without gateway

KWP
– CAN bus 500Kbps
: This type will be use when connect to car with CAS3 or
CAS3+

BMW EWS KLine : When connect EWS with CAS PLUG, choose this type

BMW F-Series : This type can connect to CAS4 in BWM F-Series
(
PICTURE
5.1)

Connect : Connect to CAS system. Attention: EWS
don’t support this
(see special
Attention 1) . After connect to CAS, there will display detail information in CAS
identification. Auto Detect only support connect operate, you must choose a specific
type before you do other operations.

CAS identification:

CAS ID : CAS identification number

CAS type : CAS type is very important, the type shown here is detected by