BMW S 1000R 2018, Rider'S Manual

Page: 55 / 228

Anti-theft alarm (DWA)
with anti-theft alarm system
(DWA)
OE
Activation
Switch on ignition ( 44).
Adjust DWA ( 54).
Turn off ignition.
If the DWA is activated, the
DWA is automatically activated
after the ignition is switched
off.
DWA is active after approx. 30
seconds.
Turn indicators are illuminated
twice.
Confirmation tone sounds
twice (if programmed).
DWA is armed.
Alarm signal
The DWA alarm can be set off
by:
Motion sensor
Switching on ignition with an
unauthorized ignition key.
Disconnecting the DWA from
the motorcycle battery (DWA
battery takes over the power
supply – alarm sound only, haz-
ard warning lights do not flash).
If the DWA battery is discharged
all functions remain operational;
the only difference is that the
alarm cannot be set off if the
system is disconnected from the
motorcycle battery.
The duration of the alarm is ap-
prox. 26 seconds. During the
alarm, an alarm tone sounds and
the turn indicators flash. The
type of alarm sound can be set
by an authorized BMW Motorrad
retailer.
If an alarm was triggered while
the motorcycle was unattended,
the rider is notified accordingly
by an alarm tone sounding once
when the ignition is switched
on. The DWA LED then signals
the reason for the alarm for one
minute.
Light signals on DWA LED:
1 flash: Motion sensor 1
2 flashes: Motion sensor 2
3 flashes: ignition turned on
with unauthorized ignition key
4 flashes: DWA disconnected
from motorcycle battery
5 flashes: motion sensor 3
Deactivation
Place emergency-off switch in
normal operating position.
Switch on the ignition.
Turn indicators light up once.
Confirmation tone sounds once
(if programmed).
DWA is now switched off.
4
53
z Operation