BMW S 1000R 2015, Rider'S Manual

Page: 48 / 207

Anti-theft alarm (DWA)
with alarm system (DWA) OE
Activation
Switching on ignition ( 40).
DWA adjusting ( 47).
Switch off the ignition.
If the alarm system (DWA) is
activated, then the alarm sys-
tem (DWA) will be armed auto-
matically when the ignition is
switched off.
Activation takes approximately
30 seconds to complete.
Turn indicators flash twice.
Confirmation tone sounds
twice (if programmed).
Anti-theft alarm (DWA) is act-
ive.
Alarm
An alarm can be triggered by:
motion sensor
an attempt to use an unau-
thorised key to switch on the
ignition
disconnection of the DWA anti-
theft alarm from the motor-
cycle's battery (DWA internal
battery in the anti-theft alarm
provides power - alarm tone
only, the turn indicators do not
flash).
All functions are sustained even
if the internal battery of the DWA
anti-theft alarm system is flat; the
only difference is that an alarm
cannot be triggered if the system
is disconnected from the motor-
cycle's battery.
An alarm lasts for approximately
26 seconds. While an alarm is in
progress an alarm tone sounds
and the turn indicators flash. The
type of alarm tone can be set by
an authorised BMW motorcycle
dealer.
If an alarm was triggered while
the motorcycle was unattended,
the rider is notified accordingly
by an alarm tone sounding once
when the ignition is switched on.
The DWA LED then indicates
the reason for the alarm for one
minute.
The meanings of the flash codes
are as follows:
Flashes 1x: Motion sensor 1
Flashes 2x: Motion sensor 2
Flashes 3x: Ignition switched
on with unauthorised key
Flashes 4x: Disconnection of
the DWA anti-theft alarm from
the motorcycle's battery
Flashes 5x: Motion sensor 3
Deactivation
Kill switch in operating position
(run).
Switch on the ignition.
4
46
z Operation
ProCarManuals.com