BMW R nineT 2015, Rider'S Manual

Page: 72 / 157

General instructions
The "Maintenance" chapter de-
scribes work involving the check-
ing and replacement of wear
parts that can be performed with
a minimum of effort.
If special tightening torques are
to be taken into account for
assembly, these are listed. An
overview of all required tightening
torques is contained in the
chapter "Technical Data".
Further information about main-
tenance and repair work can be
obtained on DVD through your
authorized BMW Motorrad re-
tailer.
Special tools and thorough spe-
cialized knowledge are required
to carry out some of the work.
If you are in doubt, consult an
authorized workshop, preferably
your authorized BMW Motorrad
retailer.
Onboard tool kit
Standard tool kit
1 Open-ended wrench
Wrench size: 14
Adjust mirror arm
(
38).
2 Torx wrench T40
Adjusting headlight
3 Reversible screwdriver with
Phillips and straight blade
Adjusting damping on
rear wheel (
39).
Replacing bulbs for
dipped and main-beam
headlights (
89).
3 Replacing bulb for park-
ing light (
90).
Replacing bulb for front
and rear turn indicator
(
91).
4 Screwdriver handle
Topping up engine oil
(
74).
Use with screwdriver bit.
Front wheel stand
Installing front wheel
stand
ATTENTION
Motorcycle standing only on
a front wheel stand and its
rear wheel.
Component damage cause by
tipping over.
Place the motorcycle on a rear
wheel stand first and then lift it
with the front wheel stand.
8
70
z Maintenance
ProCarManuals.com