BMW R 1250RS, Rider'S Manual

Page: 58 / 279

Have the fault rectified as
quickly as possible by a
specialist workshop, preferably
an authorised BMW Motorrad
Retailer.
ABS Pro failed
with riding modes Pro
OE
ABS indicator and warning
light comes on.
ABS Pro failure!
Riding at mod. speed
pos. Ride carefully to
next specialist workshop.
Possible cause:
The ABS Pro control unit has
detected a fault. The ABS Pro
function is not available. The
ABS function is still available.
ABS provides support only for
braking in straight-ahead driving.
You can continue to ride. Take
note of the more detailed in-
formation on certain situations
that can lead to an ABS Pro
fault message (
151).
Have the fault rectified as
quickly as possible by a
specialist workshop, preferably
an authorised BMW Motorrad
Retailer.
ASC/DTC intervention
ASC/DTC indicator and
warning light flashes
quickly.
The ASC/DTC has detected a
degree of instability at the rear
wheel and has intervened to re-
duce torque. The indicator and
warning light flashes longer than
the ASC/DTC intervention lasts.
This affords the rider visual feed-
back on control intervention even
after the critical situation has
been dealt with.
ASC/DTC self-diagnosis
not completed
ASC/DTC indicator and
warning light flashes slowly.
Possible cause:
ASC/DTC self-diagnosis
not completed
The ASC/DTC function is
not available, because self-
diagnosis did not complete.
(The motorcycle has to reach
a defined minimum speed with
the engine running for the
wheel-speed sensors to be
checked: min 5 km/h)
Pull away slowly. The ASC/
DTC indicator and warning light
must go out after a few metres.
If the ASC/DTC indicator and
warning light continues flashing:
Seek the advice of a specialist
workshop, preferably an author-
ised BMW Motorrad dealer.
3
56
z Status indicators