BMW R 1100 S EVO, Maintenance Manual

Page: 45 / 95

00.40
•
Close the bleed screw.
•
Disconnect the brake bleeding device from the
bleed screw.
•
The procedure for changing the brake fluid in the
right brake caliper is the same as that for the
left caliper.
•
Assembly is the reverse of the disassembly pro-
cedure.
•
Top up the brake fluid until the level reaches the
“ MAX ” mark.
•
Wipe the rim of the reservoir, the rubber gaiter
and the cover to remove brake fluid, and carefully
reassemble the components.
•
If necessary, resecure the handlebars in the cor-
rect position (punch marks aligned) in accord-
ance with the tightening sequence.
•
Check the function of the brake system.
•
Recheck the brake-fluid level.
•
Place the motorcycle on its centre stand.
•
Turn the handlebars to the
right
.
Required level with new brake pads:
(Initial fill quantity) ............................................ MAX
(exactly between the centre (point) of the sight glass
and the top edge of the marking ring)
•
Handlebar centred.
•
Check that the front wheel is on the ground.
Minimum fluid level
Brake pads worn
not less than .............. the centre of the sight glass
Brake fluid ....................................................DOT 4
X
Tightening torque:
Front brake caliper bleed screw ..................... 9 Nm
Handlebars tightening sequence:
1. Front connection to system
in direction of travel...................................... 21 Nm
2. Rear connection in direction of travel ....... 21 Nm
34 00 035
[Without Integral ABS]
Bleeding/changing brake fluid in rear
system
L
Note:
This description applies to brake filling and bleeding
devices with vacuum extraction of the brake fluid at
the brake caliper.
If other devices are used, comply with their manu-
facturers ’ instructions.
e
Important:
Do not allow brake fluid to come into contact with
painted motorcycle parts as brake fluid destroys
paint.
•
Place motorcycle on its centre stand.
•
Remove right-hand rear panel if necessary.
•
Remove rear reservoir cap, draw off the
old brake fluid and clean the reservoir.
•
Refit the reservoir cap.
•
Remove the brake caliper.
•
Remove rear brake pads.
•
Move the brake caliper to a horizontal position.
•
Use the reset device, BMW No. 34 1 531 , and
the adapter, BMW No. 34 1 536 , to press the
pistons completely back and to position them.
•
Remove reservoir cap with rubber diaphragm,
draw off the old brake fluid and clean the reser-
voir.
R28000111
MAX
R28000170
34 1 531
34 1 536