BMW R 1100 S EVO, Maintenance Manual, Page: 43 / 95

00.38
34 21 200
Replacing brake pads, rear
brake
•
Remove keeper (arrow) from retaining pin.
•
Drive the retaining pin out towards the wheel
side.
•
Remove brake caliper.
•
Remove brake pads.
e
Important:
[Integral ABS] Press back pistons in brake caliper
brake pad just far enough to allow the brake disc to
be slipped in.
The fluid in the wheel circuit reservoir must not rise
above “ MAX ” .
Risk of fluid loss.
If fluid escapes, proceed in accordance with the in-
structions for filling the reservoir.
•
Force back the pistons.
•
Check the springs for correct seating and instal-
lation position.
– The engraved arrow indicates the direction of
travel.
•
Installation is the reverse of the removal proce-
dure.
L
Note:
Always wait for the BMW Integral ABS to complete
its self-diagnosis after the ignition is switched on.
Do not operate the brake lever until self-diagnosis is
complete.
•
Perform a function check on the brake system
with the ignition switched on.
X
Tightening torque:
Brake caliper to rear wheel drive .................. 40 Nm
R28000160
R22000280