BMW K 1600GT, Rider'S Manual

Page: 132 / 209

General instructions
The Maintenance chapter de-
scribes straightforward proced-
ures for checking and replacing
certain wear parts.
Special tightening torques are lis-
ted as applicable. The tightening
torques for the threaded fasten-
ers on your vehicle are listed in
the section entitled "Technical
data".
You will find information on more
extensive maintenance and repair
work in the Repair Manual on
DVD for your vehicle, which is
available from your authorised
BMW Motorrad dealer.
Some of the work calls for spe-
cial tools and a thorough know-
ledge of the technology involved.
If you are in doubt consult a
specialist workshop, preferably
your authorised BMW Motorrad
dealer.
Toolkit
Standard toolkit
1 Screwdriver handle
2 Reversible screwdriver
blade
Phillips PH1 and Torx T25
Adjust the damping for
rear wheel (
79).
3 Torx wrench, T25/T30
T25 on short end, T30 on
long end
Replacing bulb for
high-beam headlight
(
148).
3 Adjust the shift lever
(
78).
Removing number-plate
carrier.
Engine oil
Checking engine oil level
WARNING
Engine-oil level too low.
Risk of accident due to the en-
gine seizing.
Always make sure that the oil
level is correct.
ATTENTION
The oil level varies with the
temperature of the oil. The
higher the temperature, the
higher the level of oil in the
sump.
Misinterpretation of the oil level
Check the oil level only
after a lengthy ride or when
8
130
z Maintenance