BMW F 800 R 2013, Rider'S Manual, Page: 96 / 145

Insert the speed sensor into
the bore and install screw
1 .
Adjust chain sag ( 86).
Front-wheel stand
Installing front-wheel
stand
The BMW Motorrad front
wheel stand is not designed
to support the motorcycle
without the assistance of an
auxiliary stand. A motorcycle
resting only on the front wheel
stand and the rear wheel can
topple.
Place the motorcycle on an aux-
iliary stand before lifting the front
wheel with the BMW Motorrad
front-wheel stand.
Make sure the ground is level
and firm and place the mo-
torcycle on a suitable auxiliary
stand.
with centre stand
OA
Make sure the ground is level
and firm and place the motor-
cycle on its centre stand.
Use basic stand (83 30 0 402
241) with front-wheel adapter
(83 30 0 402 242).
Slacken adjusting screws 1 .
Push the two adapters 2 apart
until the front forks fit between
them. Adjust the adapter studs
to suit the front suspension.
Use locating pins
3 to set the
front-wheel stand to the de-
sired height.
Centre the front-wheel stand
relative to the front wheel and
push it against the front axle.
Align the two adapters 2 so
that the front forks are securely
seated.
Tighten adjusting screws
1 .
8
94
z Maintenance
ProCarManuals.com