BMW F 800 GS Adventure 2015, Rider'S Manual, Page: 67 / 184

Reason for triggering of
the alarm
After the alarm function has been
deactivated, the alarm system
LED indicates the reason for any
alarm activation which may have
occurred for one minute:
1x flash: motion sensor; motor-
cycle was tilted forward/back
2 flashes: motion sensor; mo-
torcycle was tilted to the side
3 flashes: ignition switched on
with unauthorized key
4 flashes: DWA disconnected
from motorcycle battery
Note on alarm triggering
If an alarm was triggered after
the last activation of the alarm
function, then this is pointed out
with a single signal tone after the
ignition is switched on.
Deactivation
with anti-theft alarm system
(DWA)
OE
Deactivate alarm function
Press button 1 of remote con-
trol once or switch on ignition
with an authorized key.
NOTICE
The alarm function can only be
deactivated with the ignition key
if the emergency ON/OFF switch
is in the operating position.
NOTICE
If the alarm function is
deactivated by means of the
remote control and the ignition
then not switched on, the
alarm function is automatically
reactivated after 30 seconds if
"Activation after ignition off" has
been programmed.
Turn indicators light up once.
Alarm tone sounds once (if
programmed).
Alarm function is deactivated.
Protection of the battery
(anti-theft alarm system
deactivated)
After approx. one hour in the
activated state, the receiver
for the remote control in the
DWA switches off to protect the
battery. The ignition must be
switched on to deactivate the
alarm function after this period.
5
65
z Anti-theft alarm system DWA
ProCarManuals.com