BMW C 650 Sport, Rider'S Manual

Page: 99 / 170

Remove five screws 1 on rear
wheel, holding wheel as you do
so.
Lower rear wheel to the ground
and roll out toward rear.
Installing rear wheel
WARNING
Use of a wheel which does
not comply with series speci-
fications.
Malfunctions during control inter-
ventions by ABS and ASC.
Please see the information on
the effect of wheel sizes on the
ABS and ASC chassis control
systems at the beginning of
this chapter.
ATTENTION
Tightening of screwed con-
nections with incorrect tight-
ening torque.
Damage or loosening of screwed
connections.
Always have the tightening
torques checked by a spe-
cialized workshop, preferably
an authorized BMW Motorrad
retailer.
Roll and mount rear wheel onto
rear wheel support.
Fit five screws 1 and tighten
diagonally with specified
torque.
Rear wheel on output
shaft
Tightening sequence: tighten
diagonally
44 lb/ft (60 Nm)
Calibrating ASC ( 52).
BMW Motorrad front
wheel stand
Mount front wheel stand
The base stand and its acces-
sories are available through your
authorized BMW Motorrad re-
tailer.
Make sure ground is level and
firm and place Maxi-Scooter on
its center stand.
Use basic stand with front
wheel mount.
8
97
z Maintenance