BMW Motorrad S 1000 RR, Rider'S Manual

Page: 121 / 320

115
with Dynamic Damping Con-
trol (DDC) OE
Calibrating DDC ( 118).
SWINGING ARM
with Race package OE
or
with M Package OE
Adjusting swinging arm
The swinging arm pivot point
can be adjusted to three levels.
Additional tools such as an en-
gine lifter or footrest stand are
required, however, they will not
be dealt with in detail here. If
you are in doubt as to whether
you would be able to com-
plete this work, contact a spe-
cialist workshop, preferably a
BMW Motorrad Retailer.
Adjusting swinging arm pivot
point
Make sure the ground is level
and firm and place the motor-
cycle on its stand.
Lift motorcycle with an engine
lifter or another suitable jack,
so that there is no load on the
rear wheel swinging arm.
Loosen quick-release axle
nut 1 .
Loosen lock nuts 3 on left and
right.
Use the adjusting screws 2 on
left and right to significantly
increase chain sag.
Make sure that scale read-
ings 4 are the same on left
and right.
Remove nut 1 and washer 2 .
Remove fixing screw 3 .