BMW Motorrad R nineT/5, Rider'S Manual

Page: 103 / 183

Lighting
Replacing bulbs for low-
beam and high-beam
headlight
Switch off the ignition ( 39).
Make sure the ground is level
and firm and place the motor-
cycle on its stand.
Removing reflector (
100).
Disconnect connector 1 for
low-beam and high-beam
headlight.
Ease rubber cap
2 off the light
housing.
Press wire spring clip 1 down
and swing it aside clear of the
lock, then flip the spring clip up
to open.
Remove bulb
2 for high-beam
and low-beam headlight care-
fully from the light housing.
Replace the defective bulb.
Bulb for low-beam and
high-beam headlight
H4 / 12 V / 60/55 W
Hold the bulb by the base only,
in order to keep the glass free
of foreign matter.
Insert bulb 1 into the light
housing.
Flip wire spring clip
2 closed
and seat it in the lock.
Install rubber cap 1 .
8
101
z Maintenance