BMW Motorrad R nineT/5, Rider'S Manual, Page: 49 / 183

Anti-theft alarm (DWA)
with anti-theft alarm (DWA) OE
Activating DWA
Switch on the ignition ( 38).
Adjust the DWA settings
(
48).
Switch off the ignition.
If the alarm system (DWA) is
activated, the DWA will be
armed automatically when you
switch off the ignition.
Activation takes approximately
30 seconds to complete.
Turn indicators flash twice.
Confirmation tone sounds
twice (if programmed).
Anti-theft alarm (DWA) is act-
ive.
Alarm signal
A DWA alarm can be triggered
by:
Motion sensor
An attempt to use an unauthor-
ised ignition key to switch on
the ignition.
Disconnection of the DWA
anti-theft alarm from the mo-
torcycle's battery (DWA in-
ternal battery in the anti-theft
alarm provides power - acous-
tic alarm only, the turn indicat-
ors do not flash).
All functions are sustained even
if the internal battery of the DWA
anti-theft alarm system is flat; the
only difference is that an alarm
cannot be triggered if the system
is disconnected from the motor-
cycle's battery.
The alarm signal continues for
approx. 26 seconds. While a
DWA alarm is in progress an
acoustic alarm sounds and the
turn indicators flash. The type
of acoustic alarm can be set by
an authorised BMW Motorrad
dealer.
If a DWA alarm was triggered
while the motorcycle was un-
attended, the rider is notified
accordingly by an alarm tone
sounding once when the ignition
is switched on. The DWA LED
then indicates the reason for the
DWA alarm for one minute.
Light signals issued by the
DWA LED:
Flashes 1x: motion sensor 1
Flashes 2x: motion sensor 2
Flashes 3x: ignition switched
on with unauthorised vehicle
key
Flashes 4x: disconnection of
the DWA anti-theft alarm from
the motorcycle's battery
Flashes 5x: motion sensor 3
4
47
z Operation