BMW Motorrad R 18, Rider'S Manual

Page: 49 / 158

45
Alarm signal
The DWA alarm signal can be set off by:
Motion sensor
Switching on the ignition with an unautho-
rized ignition key.
Disconnecting the DWA from the vehi-
cle battery (DWA battery takes over the
power supply – alarm sound only, hazard
warning lights do not flash).
If the DWA battery is discharged all func-
tions remain operational; the only difference
is that the alarm cannot be set off if the sys-
tem is disconnected from the motorcycle
battery.
The duration of the alarm signal is approx.
26 seconds. During the DWA alarm, an
alarm tone sounds and the turn indicators
flash. The type of alarm tone can be set by a
BMW Motorrad retailer.
A triggered alarm signal can be canceled
at any time by pressing the button 1 of the
radio-operated key without deactivating the
DWA.
If a DWA alarm was set off while the motor-
cycle was unattended, the rider is notified
accordingly by an alarm tone sounding once
when the ignition is switched on. The DWA
LED then signals the reason for the DWA
alarm for one minute.
Light signals on DWA LED:
1 flash: motion sensor 1
2 flashes: motion sensor 2
3 flashes: ignition turned on with unautho-
rized ignition key
4 flashes: DWA disconnected from motor-
cycle battery
5 flashes: motion sensor 3
Deactivating the DWA
Switching on ignition ( 33).
Briefly press button 1 .
Turn indicators are illuminated once.
Confirmation tone sounds once (if pro-
grammed).
DWA is switched off.
Setting the DWA
Switching on ignition ( 33).
Select SETUP ( 40).
Briefly press button 1 repeatedly until
SET DWA
is displayed.
Briefly press button 2 to change the ad-
justed value.
The following settings are available: