BMW Motorrad R 1250 GS 2020, Rider'S Manual

Page: 50 / 294

44 DISPLAYS
Fall sensor defective
Fall sensor faulty.
Have checked by a
specialist workshop.
Possible cause:
The fall sensor is not function-
ing.
Contact an authorized service
facility, preferably an autho-
rized BMW Motorrad retailer.
Side stand monitoring faulty
Side stand monitor-
ing faulty. Onward
journey possible. Stop
engine when stationary!
Have checked by work-
shop.
Possible cause:
The side-stand switch or its
wiring is damaged. The en-
gine is switched off when the
speed falls below 5 km/h, and
the ride cannot be resumed.
Contact a specialist work-
shop, preferably an authorized
BMW Motorrad retailer.
ABS self-diagnosis not
completed
flashes.
Possible cause:
ABS self-diagnosis rou-
tine not completed
ABS is not available, as the
self-diagnosis routine was
not completed. (The motor-
cycle must reach a specified
minimum speed before the
system can check operation
of the wheel speed sensors:
3 mph (5 km/h))
Ride off slowly. Please note
that the ABS function is only
available after the self-diagno-
sis has completed.
ABS fault
lights up.
Limited ABS avail-
ability! Onward
journey possible.
Ride carefully to next
specialist workshop.
Possible cause:
The ABS control unit has
detected an error. The
partial integral brake and the
Dynamic Brake Control function
have failed. The ABS function
is limited.
It remains possible to con-
tinue riding. Observe addi-
tional information on special