BMW Motorrad R 1250 GS 2002, Rider'S Manual

Page: 61 / 338

55
Hill Start Control cannot be
activated
Crossed-out holding sym-
bol is displayed.
Possible cause:
Hill Start Control cannot be ac-
tivated.
Retract the side stand.
Hill Start Control functions
only when the side stands are
folded in.
Start the engine.
Hill Start Control functions
only when the engine is run-
ning.
Gear not trained
with shift assistant Pro OE
The gear indicator flashes.
The Pro shift assistant is
not available.
Possible cause:
with shift assistant Pro OE
The gearbox sensor is not fully
trained.
Select neutral
N
and allow
the engine to idle for at least
10 seconds to teach the neut-
ral position.
Use clutch control to engage
each gear in turn and ride for
a minimum of 10 seconds in
each gear.
The gear indicator stops
flashing when the gearbox
sensor has been trained
successfully.
When the gearbox sensor is
fully trained, the Gear Shift
Assistant Pro functions as de-
scribed ( 168).
If teaching is not successful,
have the fault rectified
by a specialist workshop,
preferably an authorised
BMW Motorrad retailer.
Hazard warning lights system
is switched on
flashes green.
flashes green.
Possible cause:
The driver has switched on the
hazard warning lights system.
Operating hazard warning
flashers ( 72).
Service-due indicator
If service is overdue, the
due date or the odometer
reading at which service was
due is accompanied by the
'General' warning light show-
ing yellow.
If the service is overdue, a yel-
low CC message is displayed.
Exclamation marks also draw
your attention to the displays
for service, service appointment
and countdown distance in the
MY VEHICLE
and
SERVICE
REQUIREMENTS
menu screens.