BMW Motorrad K 1600B Series, Rider'S Manual

Page: 143 / 221

Replacing the LED turn
indicator
LED turn indicators can be com-
pletely replaced only.
Please contact a specialist
service facility for this pur-
pose, preferably an authorized
BMW Motorrad retailer.
Replace LED tail light
The LED tail light can only be
completely replaced.
Please contact a specialist
service facility for this pur-
pose, preferably an authorized
BMW Motorrad retailer.
Jump-starting
CAUTION
Touching live parts of the ig-
nition system when the en-
gine is running
Electrocution
Do not touch parts of the igni-
tion system when the engine is
running.
ATTENTION
Current too high when jump-
starting the motorcycle
Cable fire or damage to the mo-
torcycle electronics
Do not jump-start the motor-
cycle using the power socket,
only via the battery terminal.
ATTENTION
Contact between crocodile
clips of jump leads and mo-
torcycle
Danger of short circuit
Use jump leads fitted with fully
insulated crocodile clips at both
ends.
ATTENTION
Jump-starting with a voltage
higher than 12 V
Damage to the motorcycle's
electronics
The battery of the donor mo-
torcycle must have a voltage of
12 V.
Do not disconnect the battery
from the onboard electrical sys-
tem when jump-starting the
engine.
Removing seat (
83).
Allow engine on support mo-
torcycle to run while jump-
starting.
Begin by clamping one end of
the red jumper cable to the
positive terminal of the dis-
charged battery and clamping
the other end to the positive
terminal of the donor battery.
Then clamp one end of the
black jumper cable to the
8
141
z Maintenance