BMW Motorrad ConnectedRide Com U1, Operating Instructions Manual, Page: 23 / 70

19
Activate Bluetooth on the phone and in the
list of detected devices select the Com U1
entry.
When prompted for a PIN, enter "0000".
PAIRING SECOND PHONE
Requirement
Com U1 is switched on.
If necessary a second mobile phone
can be connected for telephony, music
playback or navigation. The buttons of the
BMW Motorrad communication system con-
trol only the first mobile phone.
Press button 2 and hold it down for ten
seconds.
Configuration menu
Tap button 1 twice for pairing the second
phone.
Second mobile pairing
If the LED flashes blue, the device is vis-
ible.
Activate Bluetooth on the phone and in the
list of detected devices select the Com U1
entry.
When prompted for a PIN, enter "0000".
EXTENDED PAIRING
Requirement
Com U1 is switched on.
Requirement
Telephones can be paired with extended
pairing settings to separate the handsfree
profile from the A2DP profile (media). This
is not necessary in combination with a
BMW Motorrad TFT display or navigation
device.
Press button 2 and hold it down for ten
seconds.
Configuration menu
Tap button 1 three times for pairing the
phone with the handsfree profile, tap four
times for the A2DP profile.
Phone selective pairing
or.
Media
selective pairing
If the LED flashes, the device is visible.
Activate Bluetooth on the phone and in the
list of detected devices select the Com U1
entry.
When prompted for a PIN, enter "0000".
PAIRING GPS
Requirement
Com U1 is switched on.
Communication via Bluetooth Intercom
is interrupted by voice instructions
when they are issued by the navigation
device. Mesh Intercom communications are
not interrupted. The instructions issued by
the navigation device can be output without
loss of quality during communication via the
Mesh Intercom.