BPAP System User Manual
52 / 57
25. EMC Requirements
Guidance and manufacturer's declaration - electromagnetic emissions
The device is intended for use in the electromagnetic environment specified below. The
user of the device should ensure that it is used in such an environment.
Emissions Test
Compliance
Electromagnetic Environment -
Guidance
RF emissions
CISPR 11
Group 1
The device uses RF energy only for
its internal function. Therefore its RF
emissions are very low and are not
likely to cause any interference in
nearby electronic equipment
RF emissions
CISPR 11
Class B
The device is suitable for use in all
establishments including domestic
establishments and those directly
connected to the public low-voltage
power supply network that supplies
buildings used for domestic purposes
Harmonic emissions
IEC 61000-3-2
Class A
Voltage fluctuations
/ flicker emissions
IEC 61000-3-3
Complies
WARNINGS!
• The device should not be used in the vicinity or on the top of other electronic equipment
such as cell phone, transceiver or radio control products. If you have to do so, the device
should be observed to verify normal operation.
• The use of accessories and power cord which are not specified, with the exception of cables
sold by the manufacturer of the equipment or system as replacement parts for internal
components, may result in increased emissions or decreased immunity of the equipment or
system.
• The device may be interfered with by other equipments, even if those equipments comply
with CISPR EMISSION requirements.
• During the operation of the device, due to electrostatic interference, the following
phenomena may occur: (1) Temporary loss of function or performance degradation, such as
abnormal screen display, etc. The device will return to normal after being restarted; (2)
Automatic restart of the device. These phenomena will not affect the normal use of the
device, nor will they cause permanent performance degradation or loss of function of the
device.
Summary of Contents for G3 B20A
Page 61: ...391170 ...