KAPTOR
MINI
–
User Manual
–
V0.1 - pg.61
12.9.1
Connection parameters
In this section it is possible to configure the connection parameters for data
transfer (logs, events, configuration) and the NTP server for date and time
synchronization.
ID
: it is an identifier that is used in the data transmission
phase to distinguish between multiple instruments
installed.
Connection mode
: allows the user to select the connection
and data transfer mode between HTTP and FTP. Based on
the selection, the dedicated fields for configuration are then
displayed.
Host name/IP
: server address for sending data in HTTP.
Host port
: port for connection to the server.
Data page
: this is the page to which the data stored on the
instrument are sent.
Settings page
: this is the page to which the instrument
configuration data are sent.
Date synch. page
: page used to perform a date
synchronization. In this way multiple tools can have a unique
date. This is essential in measurement campaigns where
multiple measurement points need to be compared.
Message page/Pagina messaggi
: this is the page to which
alarm messages are sent.
FTP mode
: you can choose between the standard mode
(also called PORT or active) and passive (or PASV).
FTP name/IP, FTP port
: data needed to reach the server.
FTP User, FTP Password
: needed if the server request for
authentication.
FTP dir
: folder on server in which CSV files are loaded.
FTP time out
: time, in seconds, of inactivity necessary
before considering connection closed or lost.