KAPTOR
MINI
–
User Manual
–
V0.1 - pg.39
Use it for configuration
: allows the user to use a profile
saved on the tablet memory, to change it or load it.
Rename
: it gives a new name to the profile.
Duplicate
: profile duplication. This function is useful for
changing the profile configuration keeping the copy of a
previous one.
Associate to connected instrument
:
a profile of device “A”
could be associated to a different device “B” at defined
conditions (see following paragraph).
Delete
: delete a profile.
11.6.1
Duplication and association of profiles
Duplication and association of profiles are advanced management functions.
The following paragraphs show their different uses scenarios.
11.6.1.1
Scenario 1
–
Using the same device in different monitoring points
Let us consider the case in which the same instrument must be used to measure the flow rate on alternate
weeks at different points (A, B, C, ...) of an open channel. Each point of the canal has a different section.
Once the instrument is configured for point A, it is possible to duplicate the profile, named it differently
and change the geometry of the channel. In the same way you can proceed to point C and so on. In this
way it is possible to keep saved on the tablet more profiles with different configuration for the same
instrument: during the movement, just load the correct profile without the need for further modifications.
11.6.1.2
Scenario 2
–
Using different devices with similar configuration
If you need to install more devices
(A, B, C, …)
with the same configuration, it is not necessary to repeat
all configuration procedures for each device. You should just setup the first one (A) and then follow a few
steps:
1.
Duplica
te and rename “A” profile;
2.
Conne
ct to device “B”
;
3.
Find the duplicated profile and select
“Associate to connected instrument”
;
4.
If needed, rename the device or make other changings (i.e. change ID);
5.
Load the profile on the device.
The same profile could be matched to different devices, only if they have the same hardware
and the same firmware version
.