Hardware User Manual - Argos3D – P100
Last change: 22 August 2013
Version
1.5
1.2
CE Declaration
Bluetechnix GmbH hereby declares that this Argo
3D
-P100 product is in compliance with the essential
requirements and other relevant provisions of Directive 1999/5/EC.
http://www.bluetechnix.com/goto/argos3d-p100
1.3
FCC Declaration
This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1)
this device may not cause harmful interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to
part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference when the equipment is operated in a commercial environment. This equipment generates, uses,
and can radiate radio frequency energy and, if not installed and used in accordance with the instruction
manual, may cause harmful interference to radio communications. Operation of this equipment in a
residential area is likely to cause harmful interference in which case the user will be required to correct the
interference at his own expense.
http://www.bluetechnix.com/goto/argos3d-p100
FCC ID: SSZ-A3DP100150200
Trade Name: Bluetechnix GmbH
Model: Argos3D - P100
Classification of ITE (EN55022)
This is a class A product. In a domestic environment this product may cause radio interference
in which case the user may be required to take adequate measures.
1.4
Eye Safety
Illumination: LEDs
Wavelength
850nm (typ)
In accordance with
EN62471:2008 resp.
IEC62471:2006
Output power
TBD
© Bluetechnix 2013
Page | 6
