Do Not Duplicate, Alter, or Copy without the Express Written Consent
of BlueSky Mast, Inc. Copyright 2019 Allendale LLC All Rights Reserved
350G XL
-
Lift Series
Quick Reference Sheet
-
Primary Guying Only
DEPLOYMENT
Read Manual Before Use
Refer to detailed instructions in the
350G XL Lift Series Manual at all times
Remove the Guy Leader from the
Primary Guy Ring.
Locate the four Primary Guy
Ropes with the red tab next to the
guy clip.
Clip the first Primary Guy Rope to
the round hole on the guy ring.
Walk away for the mast and
unwind ALL of the guy rope off of
the guy handle.
Clip the guy rope into the top hole
of the guy stake.
IMPORTANT: Slide the Guy Handle towards the mast approx. 7 ft.
Repeat this process on all four primary guy ropes.
(This will help prepare you for Incremental Guying)
Make sure the cam lock is locked
and lower the lift base plate to the
ground.
Insert a center mast pole onto the
lift base plate.
Raise the center mast pole
until it nest together with the
mounting pole.
Make sure the castle cuts on the
poles nest together and there is
no gold insert showing.
Release the cam lock and raise
until one inch is showing below
the cam lock.
Lock the cam lock.
Make sure the cam lock is locked
and lower the lift base plate to the
ground.
Insert a center mast pole onto the
lift base plate and raise it until it
nests together.
Release the cam lock and raise
until one inch is showing below
the cam lock.
Helpful Hint:
When raising the
mast use your finger to guide the
cable to avoid stack up / jumping.
WARNING:
If at any point the
mast begins to slip while the cam
lock is locked -
STOP
Use the 7/16 wrench provided with
the system to make adjustments to
the cam lock.
Tighten the nut on the cam lock a
quarter turn until slipping no
longer occurs.
7 ft.
1”
Lock the Cam Lock.
*Use the
Velcro Straps to secure cables
and always monitor guy ropes.
1”
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
