S L - 1 . 2 5 S E A M L O C K E R
10
•
2) Move lever into position against the channel with the lever in the open
position (away from the direction of feed)
•
3) Set the machine up against the prepared material on the channel.
•
4) Move lever in direction of the feed (tool in working position towards the end
of the end of the channel).
•
5) Switch machine on.
•
6) The machine is drawn through the channel as the driving rollers feed the
machine over the material while locking the seam.
•
7) Lock seam on channel.
•
8) Move lever into open position (away from feed direction)
•
9) Switch machine off and remove from material.
o
NOTE: Some amount of refinishing must be carried our manually at the end of the channel. This
is usually 130mm of manual work.
TRANSPORTING THE MACHINE
Ø
When transporting the machine, always carry by the machine main handle.
Ø
If transporting inside a vehicle, it is recommended to transport it on its side so as to avoid the item falling
over.
Ø
DO NOT carry the machine by the cord.
Ø
DO NOT allow the cord or plug to drag along the floor when transporting.
