44
Shenyang Bluelight Automatic Technology Co., Ltd.
BL6-DU20PX series Integrated Door Motor Controller User Manual
7
Application and Adjustment
This chapter detailed describes the steps of system design and function parameter setting
method when applying Integrated Door Motor Controller. The following descriptions are separately
for speed control application and distance control application.
7.1
Door Motor Controller Adjustment
7.1.1
Adjustment Process
To adjust the door motor controller conveniently, this section lists the parameters setting
sequence. If the external circuits and mechanical installation are all well, the adjustment can start.
The adjust process is shown in Figure 7.1.
External Wiring Check
Encoder Check
Controller Related
Parameter Setting
Encoder Check
Control Mode
Manual Adjust Running
Determine Change Speed Switch Position
Determine Change Speed Pulses Position
Change Speed Smoothly
and Open / Close the Door
Manual Adjust Running
Door Width Self-tune
F
IGURE
7.1
B
ASIC DEBUGGING PROCESS OF DOOR MOTOR CONTROLLER
7.1.2
Check Wiring
Before power on, external wiring should be checked to ensure the element and human safety.
1) Wiring according to the factory diagram;
2) Each switch works gradually and acts reliably;
3) Check the inter-phase resistances value of main circuit, and check for short circuit to ground;
4) Install each element firmly, and not cause equipment damage and personal injury.
7.1.3
Encoder Check
The pulse signal feedback from encoder is important for system to control precisely.
1) Install encoder firmly and wiring reliably.
