3
1
‡
2
*
5
4
15
STRONGARM™ ML10 VEHICLE RESTRAINT—OWNER’S MANUAL
ISSUE DATE: SEPTEMBER 29, 2014 REV.0 (PART # 038-538E)
9.0 EQUIPMENT COMPONENT ILLUSTRATIONS
9.1 COMPONENTS AS SHIPPED CHECK LIST
MOUNTING
BRACKET
‡
NOTE:
The arm is shown in the shipping
position and will need to be installed correctly.
ANCHORS
ITEM
QTY
PART NO.
DESCRIPTION
APPROX. WEIGHT
1
1
52-011130
ML10 Body
150 lb
68 kg
2
1
038-224/5
E Exterior Driver Warning
Sign (English / French /
Spanish)
0.7 lb
0.32 kg
F
S
3
1
782-371
Control Rod
7 lb
3.2 kg
ITEM # 5 - CONTROLS (OPTIONAL)
1
TLC24-A
See Sec 10.0
Automatic Lights Communication
Package (optional)
5 lb
2.27 kg
TLC24-M
See Sec 10.0
Manual Lights Communication
Package (optional)
1
032-461
Exterior Traffic Light (optional)
1.3 lb
0.6 kg
1
038-759E
Operation Placard
—
—
ITEM # 4 - HARDWARE INCLUDED:
QTY
PART NO.
DESCRIPTION
APPROX. WEIGHT
6
010-108
5/8" dia. x 6" / 152mm Anchor
Wedge
.15 lb
.06 kg
1
035-288
Mounting Bracket
—
—
ITEM # 5 - COMPONENTS
QTY
PART NO.
DESCRIPTION
APPROX. WEIGHT
1
038-538E
ML10 Owner's Manual
—
—
1
038-759E
Operation Placard
—
—
OPTIONAL
CONTROLS
*NOTE:
For sign specifications, see section 7.7
WARNING
TLC24-A
TLC24-M
OUTSIDE TRAFFIC
LIGHT STATUS
INSIDE COMMUNICATION
LIGHTS & CONTROL STATION
ENGAGE RESTRAINT
Activate the ML10 by using the control rod to
press down on the engagement arm until the
restraint arm is in the fully vertical position,
holding the ICC bar in place.
TLC24-A:
The control station light will turn
GREEN and the outside traffic light will turn
RED.
TLC24-M:
Turn the key switch to the
‘Interlocked’ position (green LED). The
outside traffic light changes to RED while
GREEN light on the control station comes on.
TLC24-A
TLC24-M
OUTSIDE TRAFFIC
LIGHT STATUS
INSIDE COMMUNICATION
LIGHTS & CONTROL STATION
OPPOSITE
SIDE
NOTE:
The truck / trailer is NOT restrained if the arm is not fully vertical and
the communication lights do not change colour as described above. Do a visual
inspection to confim that the ICC bar is securely restrained before proceeding with
loading / unloading.
OPERATING INSTRUCTIONS
Only for the ML10 and TLC24-A (Automatic) or TLC24-M (Manual)
1.
Only trained and authorized personnel may operate this vehicle
restraint.
2.
Read, understand, and follow the instructions on this document and
included manual
3.
Prior to using the vehicle restraint:
•
Ensure that the vehicle restraint is free and clear of all debris, snow,
and ice.
•
Ensure that all personnel near the vehicle restraint are aware that it
is being operated.
• Operate the vehicle restraint through one complete cycle to confirm
that it is functioning properly. If the vehicle restraint is equipped with
a communications package, confirm that the lights are working as
required.
•
Inspect unit for signs of structural damage or mechanical
malfunction. If damage is observed or the restraint fails to operate
properly, remove it from service and notify maintenance personnel
immediately.
4.
Before attempting to restrain a transport vehicle:
• Ensure that the vehicle is parked firmly against the dock bumpers.
•
If the dock leveler is equipped with a light communication package,
load and unload on green only.
•
Do not exceed the rated capacity as indicated on the serial plate.
•
Do not leave equipment or material unattended on the dock leveler.
•
Keep a safe distance from both edges.
•
If either the dock leveler or vehicle restraint fail to operate as
outlined in the accompanying manual’s operating instructions, refer
to the Troubleshooting section.
5.
If service or maintenance is required:
•
Only authorized service personnel shall maintain or service the
units.
APPLIES TO ALL DOCK LEVELER AND VEHICLE RESTRAINT
COMBINATIONS
RELEASE RESTRAINT
After loading / unloading has been completed
and the dock leveler is safely parked, release
the restraint arm by pulling up on it quickly
and firmly using the control rod. The arm will
return to the parked position.
TLC24-A:
The control station light will turn
RED and the outside traffic light will turn
GREEN.
TLC24-M:
Turn the key switch to the ‘No
Traffic’ position (red LED). The outside traffic
light changes to GREEN and the control
station light turns RED.
038-759E
www.BlueGiant.com
NOTE:
If the ICC bar is applying pressure to the restraint arm, it may be necessary
to have the driver back up the vehicle before releasing the arm.
