Jinan Blue Elephant CNC Machinery Co.,Ltd
：
Mobile
：
0086-15064026772
Web
：
26
Set Mach3 by yourself(ANVANCE).
Of course. You can make your own setting if you know mach3 very well.
Then there will be some major setting introduction here :
1. Motor output setting:
There are 4 important signal need to set. X Y Z A axis. You will see as follows . If you want X Y Z
work . You should enable it . Notice only for A , If you choose A axis ( here should be 4 driver. Not
3 , it is the the real A axis .) please enable it.
Another important point is dir low part. If you find your x axis move at wrong direction. ( like if you
press X + , it should move to left direction.) you can change √ to be × 。Then the direction will be
reversed.
Note : you can find more details in the USB board manual
1.1 1.
Mach3 X、Y、Z、A Axis config as shown below: (Config => Ports and Pins)
2. Motor tuning setup as shown below: (Config => Motor Tuning)
BLUE ELEPHANT BLUE ELEPHANT BLUE ELEPHANT
BLUE ELEPHANT BLUE ELEPHANT BLUE ELEPHANT
BLUE ELEPHANT BLUE ELEPHANT BLUE ELEPHANT
BLUE ELEPHANT BLUE ELEPHANT BLUE ELEPHANT
BLUE ELEPHANT BLUE ELEPHANT BLUE ELEPHANT
BLUE ELEPHANT BLUE ELEPHANT BLUE ELEPHANT BLUE ELEPHANT
BLUE ELEPHANT BLUE ELEPHANT BLUE ELEPHANT BLUE ELEPHANT
BLUE ELEPHANT BLUE ELEPHANT BLUE ELEPHANT BLUE ELEPHANT
BLUE ELEPHANT BLUE ELEPHANT BLUE ELEPHANT BLUE ELEPHANT
BLUE ELEPHANT BLUE ELEPHANT BLUE ELEPHANT BLUE ELEPHANT