Blue Diamond EXTREME DUTY SNOW BLOWER 68, Operation And Maintenance Manual, Page: 26 / 70

26
Extreme Duty Snow Blower Operation and Maintenance Manual
Operation
Attachment Control Harness
Connecting Attachment Control Harness
Remove storage cap on the machine and
snowblower control harness ends. Route and
connect the snow blower’s attachment control
harness to the machine attachment control
connector bulkhead.
Secure harness to route with
existing snowblower hoses.
Disconnecting Attachment Control Harness
Disconnect the snow blower attachment control
harness from the attachment control connector
bulkhead. Replace storage caps on the bulkhead
and snow blower connector ends.
Disconnecting Attachment From The
Machine
Relieve auxiliary hydraulic pressure. (See the
machine’s Operator’s Manual for correct
procedure.)
Park the machine and attachment on a flat level
surface. Lower the attachment flat on the ground.
Leave the operator’s position. (See “Leaving The
Operator’s Position” on page 24.)
Disconnect attachment hydraulic hoses from the
machine.
Disengage locking pins / wedges. (See the
machine’s Operator’s Manual for correct
procedure.)
Enter the operator’s position. (See “Entering The
Operator’s Position” on page 24.)
Slowly tilt the machine’s mounting plate forward
until the attachment mounting frame is free from
the machine’s mounting plate.
Drive the machine slowly backward, away from
the attachment.