Blue Diamond EXTREME DUTY SNOW BLOWER 68, Operation And Maintenance Manual, Page: 22 / 70

22
Extreme Duty Snow Blower Operation and Maintenance Manual
Operation
Attachment Inspection
Daily Inspection
NOTE: Inspect the attachment by performing a
walk around daily before and after use.
Use the following inspection checklist
as a guideline.
Check the following items every 10 hours of
operation:
• Verify that the snow blower is properly
connected to the machine.
• Check that all shields and guards are in place.
• Check for damaged or leaking hydraulic hoses
or fittings. Replace if necessary.
• Check the snow blower mounting hardware for
wear or damage. Inspect the pins and mount
(on the attachment) for wear or damage.
Repair or replace damaged parts if necessary.
Weekly Inspection
Check the following items every 40 hours of
operation:
• Check the cutting edge for wear or damage.
• Inspect the snow blower fan and auger for
cracks, bends, or damage.
• Check the discharge chute and deflector for
wear or damage.
• Check all bolts for tightness.
Replace any worn or damaged parts.
Monthly Inspection
• Inspect the snow blower frame and all welds
for cracks or damage.
• Check skid plates for wear.
• Check that all bolts are tight.
• Check for damaged or missing decals.
Replace if necessary.
Machine Requirements
Skid Steer Snow Blower
This snowblower is for use with small to large skid
steer models and some compact wheel loader
models (Machine). Compact wheel loader must
have low quick-tach mount (skid steer style) and
creep control ability for 0.4 mph minimum ground
speed.
SNOW BLOWER
MODEL
HYDRAULIC
FLOW
LIFT
CAPACITY
68”
11-35 GPM 915 lbs
72”
11-35 GPM 950 lbs
84”
24-35 GPM 1050 lbs
HYDRAULIC FLOW OPTIONS
Hydraulic Package
Skid Steer Requirements
15
11-16 GPM
20
17-20 GPM
22
21-23 GPM
25
24-25 GPM
30
25-29 GPM
35
30-35 GPM