Blue Coat SG810 series, Installation Manual

Page: 67 / 110

P/N 231-02941 SG810 Installation Guide page 67
Setting the Default Boot System
The system will always try to boot the newest software image, which might be the
image installed on the new disk drive. If you do not want to boot that software
image on the next reboot, you must reselect the default software image. Using the
Management Console, configure the appliance to boot the desired system image.
To set the default boot system using the Management Console:
1
Select
Maintenance
>
Upgrade
>
Systems
.
In the
SG Appliance Systems
section, locate the desired software image and
select the
Default
radio button.
The SG appliance
Systems
tab displays the five available systems. Empty
systems are indicated by the word
Empty
. The system currently running is
highlighted in blue and cannot be replaced or deleted.
Figure 3-6: Setting the default boot system