Blue Coat SG810 series, Installation Manual

Page: 59 / 110

P/N 231-02941 SG810 Installation Guide page 59
Section G: Configuring the Front-Panel LCD Behavior
The front-panel LCD turns off after 30 seconds by default. This behavior is
configurable—you can set the LCD to remain on at all times, to turn off after a
specified length of time, or to flash (the flash setting can be helpful if you need to
find one SG810 in a room full of them).
The front-panel LCD cannot be configured through the Management
Console—you must use the CLI.
To configure the front-panel LCD through the CLI:
1
Open a terminal session with the SG810; at the standard-mode command
prompt, enter
enable
and your privileged-mode password.
SGOS> enable
Enable Password: ******
SGOS#
2
At the privileged-mode command prompt, enter the
configure terminal
command to access the privileged mode configure commands:
SGOS# configure terminal
SGOS#(config)
3
At the
(config)
prompt, enter the
front-panel
command to access the
front-panel mode commands and to configure the front-panel LCD behavior.
SGOS#(config) front-panel
SGOS#(config front-panel)
SGOS#(config front-panel) backlight flash
SGOS#(config front-panel) backlight state { off | on | timeout }
SGOS#(config front-panel) backlight timeout seconds