Blue Coat SG810 series, Installation Manual

Page: 51 / 110

P/N 231-02941 SG810 Installation Guide page 51
e.
Verify the IP addresses.
Type
Y
to confirm the serial number of the Director. The SG810 is
registered.
or, Type
N
to abort the registration process.
f.
Figure 2-11: Screen to verify Director serial number and register with Director
4
If you would like to configure the SG810 using the Director, go to the Director
Management Console or the Director CLI.
5
To log in to the serial console right away, press <
Enter
> three times.
A menu displays offering two choices:
1) Command Line Interface
2) Setup Console
Choose setup mode: R
IP address[0.0.0.0]:10.0.0.146
IP subnet mask [255.255.255.0]:
Director IP address [0.0.0.0]:
10.0.0.146
IP
Registration password:
Appliance name (optional):
You have entered the following IP addresses:
IP address:10.0.0.1
IP subnet mask: 255.255.255.0
Director IP: 10.0.0.146
IP gateway: 10.9.44.1
Choose setup mode: R
IP
IP
Director
IP gateway [0.0.0.0]:10.0.1.1
Registration password:
Appliance name (optional):
You have entered the following IP addresses:
IP subnet mask: 255.255.255.0
IP gateway: 10.9.44.1
Would you like to change any of them? Y/N N
Connecting to 10.0.0.146 to determine Director serial number
This can take up to 90 seconds ... please wait
Director reports serial number: 1234567899
Is that the expected serial number? Y/N
Y
Connecting to 10.0.0.146 to register with Director 1234567899
Registration succeeded
Press "enter" three times to activate the serial console
b
e
d