Blue Coat SG810 series, Installation Manual

Page: 30 / 110

P/N 231-02941 SG810 Installation Guide page 30
Section B: Initial Configuration Using the Web Setup
Wizard
This section describes how to configure the SG810 with a Web browser.
Requirements
To configure your SG810 using a browser, you must meet the following
requirements.
• The browser must support Javascript and Javascript must be enabled.
• The browser must not be proxied. For information about proxied browsers,
see
“The Web Setup Wizard Page is Not Accessible” on page 73.
• Your SG810 must not already be configured.
Note: If the SG810 has already been configured, you cannot access the Web
wizard unless you reset the SG810 to factory defaults as described in
“Resetting the SG510 to Factory Defaults” on page 77.
• You must configure the SG810 IP address, subnet mask, gateway, using the
front panel or the serial console before accessing the Setup Wizard through
the Web browser.
To configure the SG810 using the Web Setup Wizard:
1
Connect the SG810 to a PC or place it within your network, and configure an
IP address, subnet mask, and IP gateway using the serial console or the front
panel buttons. See
“Overview of First-Time Configuration” on page 20.
2
Enter the following URLs into your browser:
https://proxysg_IP:8083/
where, proxysg_IP is the IP address you configured for this SG810 using the
front panel or the serial console.