Blue Coat SG810 series, Installation Manual

Page: 17 / 110

P/N 231-02941 SG810 Installation Guide page 17
• Green : the SG810 is powered on and at least minimally configured
3
The steps below show a typical, first-time, start-up sequence.
•
The Power LED lights up and the LCD becomes green and displays the
name
Blue Coat
.
•
The Power LED starts of solid amber and then begins flashing green and
amber.
•
After a moment, the disk drive LEDs corresponding to the disk drives
that are installed light up. The LCD displays
IP address not configured
(if a
first-time configuration has not been done) or it cycles between CPU
utilization and the hostname.
Figure 1-11: Verify Successful Power On
The SG810 comes with all software installed. To configure an SG810 for the first
time go to
“Configure an SG810” on page 19.
LCD
Disk Drive
LEDs (4)
Power
LED