Blue Coat SG510 Series, Installation Manual

Page: 79 / 110

P/N 231-02833 Blue Coat SG510 Installation Guide page 79
Creating A Static Route to the SG510
I f your SG510 is running 4.2.2.x or later and you want to use the Web-based
initial configuration method, you might need to create a static route from your PC
to one of the “soft” initial configuration IP addresses.
To create a static route to the SG510
1
Access the Windows command prompt.
2
Enter the following command:
C:\> route add
proxySG_ip_address
mask
subnet_mask client_ip_address
In the preceding command,
soft_ip_address
is one of the “soft” IP addresses the
SG510 listens for and
client_ip_address
is the address of the PC.
For example:
C:\> route add 10.0.0.254 mask 255.255.255.255 10.2.11.155
3
Verify the static route by entering the following command:
C:\> route print
You cannot access the serial console
If you have connected a serial cable to the SG510 but you cannot open the serial
console, do the following:
• Check cable connections.
• Check configuration information at the terminal emulator for the correct
settings (see
“Initial Configuration Using a Direct Serial Port Connection” on
page 38 for information).
• Verify that the serial cable is a Null Modem type cable. The cable pin outs can
be found at
http://www.bluecoat.com/support/self-service/1/pinouts.html
• Use a different cable.
You cannot access the Management Console
If the browser fails to connect to the SG510 successfully, complete the following
steps to identify the problem.
• Verify that you have the correct IP address and port for the SG510 in your
Web browser (the default port is 8082).