Blue Coat SG510 Series, Installation Manual

Page: 67 / 110

P/N 231-02833 Blue Coat SG510 Installation Guide page 67
Section G: Configuring a Front-Panel PIN
The front panel allows you to reconfigure the initial settings of the SG510, which
can represent a security risk. Setting a front-panel PIN limits access to authorized
personnel only.
This procedure is only available through the CLI—you cannot set a front-panel
PIN through the Management Console.
To Configure a Front-Panel PIN:
1
Connect to the SG510 CLI and access the privileged-mode configure
commands (see
“Logging on to the SG510” on page 62).
2
From the privileged mode command prompt, change the SG510 front panel
PIN by entering one of the following commands:
SGOS#(config) security front-panel-pin PIN
-or-
SGOS#(config) security hashed-front-panel-pin hashed_PIN
where
PIN
is an unhashed PIN and
hashed_PIN
is a PIN in hashed format.
After entering one of these commands, anyone who attempts to configure the
SG510 through the front panel is prompted to enter the PIN.
Note: The front-panel PIN commands are hidden commands. If you enter
the commands listed above and receive an unrecognized command
message, enter the following command and try again:
SGOS#(config) reveal-advanced all