Blue Coat SG510 Series, Installation Manual

Page: 59 / 110

P/N 231-02833 Blue Coat SG510 Installation Guide page 59
Figure 2-24: Remote Initial Configuration Page—Secure the Serial Port
7
Click
Generate URLs
.
• If a dialog appears with the message
Errors Found
, click
OK
and correct the
errors in the Initial Configuration page. Click
Generate URLs
again.
• If all the fields in the form are correct, a section called Configuration
URLs appears at the bottom of the page. A list of URLs are provided in
this section—one for each of the five potential network addresses to
which the SG510 might respond. Which URL works best depends on the
network topology into which the SG510 is placed. At least one of the
URLs should work in your network environment.
8
Copy and send one or more of the URLs to the local administrator who will
complete the configuration. Verify that the local administrator has all
required information, such as how to properly place the SG510 into the
network and, if necessary, how to modify the network parameters on his or
her PC so that the generated URL works to configure the appliance.
Step Two—Complete the Configuration
Perform the following procedure if you are at the same location as the SG510 and
you are planning to complete the initial configuration using a URL provided to
you by a remote administrator.
To Configure the SG510 Using a Remotely Generated URL:
1
Place the SG510 into your network using one of the following methods:
• Change the IP address of the PC so that it is on one of the subnets the
appliance uses for initial configuration:
https://10.0.0.254:8083/