Blue Coat SG510 Series, Installation Manual

Page: 53 / 110

P/N 231-02833 Blue Coat SG510 Installation Guide page 53
Figure 2-20: Initial Setup—Page Five
9
To log in to the serial console right away, press <Enter> three times.
A menu displays offering two choices:
1) Command Line Interface
2) Setup Console
10
Access the CLI or Management Console:
• Enter
1
in the serial console menu to select the CLI.
See “Logging on to the SG510 CLI” on page 64 for information about using
the SG510 CLI.
• To access the SG510 Management Console, enter the following address
into your Web browser:
https:// proxysg_IP :8082/
where proxysg_IP is the IP address that you configured for this SG510.
See “Logging on to the SG510 Management Console” on page 62 for more
information about accessing the SG510.
When you have set the basic networking parameters and connected the SG510 to
the network, you are ready to fully configure the appliance. For a list of all CLI
commands, refer to the
Blue Coat ProxySG Command Line Interface Reference . For
--------------------- (page 5 of 5) --------------------
DIRECTIONS:
The ProxySG Appliance has been successfully configured to
use IP address: "10.25.36.47"
You can connect to the command line interface or Web
interface to perform additional management tasks.
To connect to the command line interface, open the following
location from your SSH application: 10.25.36.47
To connect to the Web management interface, go to the
following location with your web browser:
https://10.25.36.47:8082/
--------------- CONFIGURATION COMPLETE -----------------
Press "enter" three times to activate the serial console