Blue Coat SG510 Series, Installation Manual

Page: 25 / 110

P/N 231-02833 Blue Coat SG510 Installation Guide page 25
Using the Front Panel to Configure Basic Network
Settings
Use the front panel to do a quick first-time configuration of the following
networking parameters on Adapter 0:
Important: A default username (
admin
) is already set on the SG510. A
unique console and enable password are generated
automatically. You can configure the passwords now, or write
down the auto-generated passwords and use them to log in,
changing them later. The enable password is not required if you
log in using a browser.
1
When the LCD displays “IP address not configured,” press the
Enter
button to
enter Configure mode.
The IP address parameter appears in the LCD, and the cursor appears as an
underscore.
2
Press the
Enter
button again to enter Edit mode.
The cursor changes to a blinking box.
Up and Down Arrow
Buttons When you push the
Up
and
Down
arrow buttons in
Configuration mode, the system cycles through the
six configurable parameters.
When you push the
Up
and
Down
arrow buttons in
Edit mode, the system cycles through the characters
available for the selected setting of the parameter (the
selected setting is the character that the cursor is over
when you push the arrow buttons).
• IP address • Subnet mask
• Gateway address • DNS address
• Console password • Enable password